7/10/2023 0 Comments Diy mushroom incubator hot bombs![]() Provided with On/Off switch, Indicators, Digital Controllers etc. ISI mark Silicon bind motors, which are connected to balanced blowers, which operates alternatively and continuously with heating and cooling. Heating is done with ISI mark strip type heaters placed near the cooling coils. Whole cooling unit is placed below the main chamber in a GI housing. ![]() Cooling is done with ISI Mark compressor of KIRLOSKAR make which is connected to thick copper coils placed in the rear of the chamber through condenser, fan motor, capacitor, relay etc. Having too high or too low a temperature will prevent your morels from growing. These temperatures decrease to around 60 degrees as the morel enters the fruiting phase after the initial spores have developed. Is maintained with an accuracy of + 0.5☌. The temperature of the surrounding environment should be between 55 to 70 degrees Fahrenheit (12 to 21 Celcius). This controller is provided with time delay relay to control the accuracy in maintaining the temperature. silicone gel duct tape some boiled (distilled/germ free) water how to assemble the heatbomb: 1. Range is from 5☌ to 60☌ and is controlled by electronically controlled by PID Microprocessor Controller with PT-100 sensor. Provided with door operated illumination lamp. Provided with double door, inner made of thick transparent full view glass and outer door is double walled metallic properly insulated with glass wool and also provided with best quality handle, gasket, lock etc. perforated stainless steel shelves with ribs to adjust the shelves at desirable height. Insulation between inner and outer wall is done with 75mm thick glass wool to prevent any heat loss. ![]() Double walled, inner made of Stainless Steel 304 quality, outer made of thick best quality Mild Steel the surface of which is primer coated for anti rusting and is duly white stove powder coated paint. ![]()
0 Comments
Leave a Reply. |